Dustino PCB Antenna

Description

This document describes DUSTINO, an Arduino MKR1000 form factor board that represents a key solution for easy and fast prototyping of the Dust wireless technology. It is Arduino IDE compatible and powered by USB or battery. It will especially be useful for both the Makers community, as an Arduino compatible board, and the R&D teams of larger entities. Being the DUSTY on the board CE and FCC certified, there's no need to certify the single board produced using Dustino, making it faster and more inexpensive to prototype and produce.

Download

Get a quote

Specifications

Main Features:

● Breakout with module with PCB antenna or U.FL connector for external antenna

● Integrates 2.4 GHz, IEEE 802.15.4e System-on-Chip, complete with Embedded Smartmesh Networking Software

● 99.999% Network Reliability in the Most Challenging RF Environments

● Sub 50µA Routing Nodes

● Serves either as a Wireless Mote, EManager or as Access Point Mote in Smartmesh IP network

● Compliant with 6LoWPAN internet Protocol (IP) and IEEE 802.15.4e Standards

Quick Specification:

● Supply Voltage: 3.3 V

● Interface : USART / ADC / SPI / I2C

● Industry-Leading Low Power Radio Technology

● Consume: 4.5 mA to Receive a Packet

● Consume 9.7 mA to Transmit at 8 dBm

● Based on Micrium µCOS-II Real Time Operating System

● Receiver Sensitivity -93 dBm

● Output Power 0 to 8 dBm

● Working Temperature -40°C to 85°C

● Dimensions 68 x 30 mm

Dusty PCB Development Boards

Breakout Dusty PCB Antenna

An extremely small module networked by SmartMesh IP with an on-board PCB antenna, incorporating a LTC5800-IPM, a highly integrated low power radio design with an ARM Cortex-M3 32-bit microprocessor running SmartMesh IP embedded networking software. SmartMesh IP wireless sensor networks are self-managing, low power internet protocol (IP) networks built from wireless nodes called motes, which can route, source or terminate data, and they behave according to the SmartMesh IP network software loaded: Wireless Mote, EManager, or Access Point Mote
Dust-ADI-Sensor

A breakout board developed to start working with Dusty PCB Ant easily. It comes with a connector with 2 screw terminals, ideal for connecting a battery pack or any 3.3V external power source. It has the standard 10-pin Dust programming header (“Dust Prgrm” on the silkscreen), which allows you to use the standard Dust interface boards and programmers to connect to Dusty, the eterna programmer or the DC9006A+DC9904A combo

Downloads:

Technical Documentation:

Programmers Guides:

UG_ITM-DOxx_ProgrammingManual

1 file(s) 278.04 KB

Download

User Guides:

ITM-DYPA or UF-B-01 User Guide Dusty Rev 1.7

Certification, Compliance and Other Documents:

Soon available for download

Get Expert Advice On Choosing the right IoT solution?

Find out how our range of IoT solutions can help your business.

Get in touch with one of our pre-sales tech friendly experts