Image

Dusty PCB Antenna

SmartMesh IP products are wireless chips and precertified PCB modules complete with ready-to-deploy wireless mesh networking software. They are built for IP compatibility and based on the 6LoWPAN and 802.15.4e standards. The SmartMesh IP product line enables low power consumption and >99.999% data reliability even in harsh, dynamically changing RF environments. Dusty is a SmartMesh IP PCBA product incorporating the LTC5800-IPM SoC running Dust's embedded SmartMesh IP networking software. The Dusty module comes complete with an onboard PCB antenna or U.FL antenna connector, crystals and modular RF certifications.

Specifications


Main features:

• PCBA module with PCB antenna or U.FL connector

• Integrated 2.4 GHz, IEEE 802.15.4e System-on-Chip, complete with Embedded SmartMesh Networking Software

• >99.999% Network Reliability in the Most Challenging RF Environments ‣ Sub 50μA Routing Nodes

• Serves as either a Wireless Mote, Embedded Manager, or Access Point Mote in a SmartMesh IP™ network depending on the loaded firmware

Quick Specification:

Ultra-low-power network
The network can run on batteries, energy harvesting, or line power

IPv6 addressability

Combines 6LoWPAN with IEEE 802.15.4e

Comprehensive security management

Allows you to configure NIST-certified AES-128 based security to meet your
requirements

Flexible configuration

Network parameters can be selected to match specific system requirements (power/latency/ bandwidth)

Fully tested network stack and manager software

Application programming interfaces are used to communicate with and to

configure the product - no user networking code necessary.

Dusty PCB Development Boards


  • Dustino PCB Antenna

    Dustino PCB Antenna

    This document describes DUSTINO, an Arduino MKR1000 form factor board that represents a key solution for easy and fast prototyping of the Dust wireless technology. It is Arduino IDE compatible and powered by USB or battery. It will especially be useful for both the Makers community, as an Arduino compatible board, and the R&D teams of larger entities. Being the DUSTY on the board CE and FCC certified, there’s no need to certify the single board produced using Dustino, making it faster and more inexpensive to prototype and produce.

    Download

    Learn more

    Buy Now

  • Breakout Dusty PCB

    Breakout Dusty PCB Antenna

    An extremely small module networked by SmartMesh IP with an on-board PCB antenna, incorporating a LTC5800-IPM, a highly integrated low power radio design with an ARM Cortex-M3 32-bit microprocessor running SmartMesh IP embedded networking software. SmartMesh IP wireless sensor networks are self-managing, low power internet protocol (IP) networks built from wireless nodes called motes, which can route, source or terminate data, and they behave according to the SmartMesh IP network software loaded: Wireless Mote, EManager, or Access Point Mote

    Download

    Learn More

    Buy Now

  • Dust-ADI-Sensor

    A breakout board developed to start working with Dusty PCB Ant easily. It comes with a connector with 2 screw terminals, ideal for connecting a battery pack or any 3.3V external power source. It has the standard 10-pin Dust programming header (“Dust Prgrm” on the silkscreen), which allows you to use the standard Dust interface boards and programmers to connect to Dusty, the eterna programmer or the DC9006A+DC9904A combo

    Download

    Learn more

    Buy Now

Downloads:


Technical Documentation:

Programmers Guides:

User Guides:

Certification, Compliance and Other Documents:

  • Soon available for download

Get Expert Advice On Choosing the right IoT solution?

Find out how our range of IoT solutions can help your business.

Get in touch with one of our pre-sales tech friendly experts